We decided to swap things around a little this week and we started pick up work again on the ‘Onion Mustang’. We work on this little lady when we have time as this is not a time critical build so far. The body shop where the car sits at the moment is cool and out the back of the yard so Yogi can just get on a do his thing, the dark complex art form of making Mustangs from bits of car, old, new or reconditioned. The car is far from being finished properly for the basic body work yet, a lot of this is temporary especially at the front end. The cowl is a serious and critical part of the front end strength, however the lower cowl has been paint prepped ready for fitting. Yogi will measure this cowl a couple of times, clamp it, measure it, tack weld it and dummy panel fit for the front, all before he even starts the proper welding.
Parts for the middle section and the rear are coming together well and the rear running gear is in. The rear axle is from a later Mustang which has been shortened specifically to fit this car. The results should be a well handling car as a result.
The wall of parts are ready and waiting, you have to smart and always be a step in front of yourself, especially when the car is on the jig and being assembled to this degree.
We have been asked a number of times if a little bling makes a difference? That choice is yours alone, but we can give you a couple of examples for a simple swap out with our stainless steel upgrade. These parts fit all the ’64 – ’66 models under hood, subtle but very effective.
Stainless Steel Hood Pin can be found here
Stainless Steel safety Latch can be found here
The original car hood is obviously painted car colour as they were at the time of build.
Replacing the parts is a large nut for the hood pin and a couple of bolts for the safety latch. The replacement bolts are not your standard bolts though, these are our new in ‘Ford’ branded Stainless Steel.
The replacement is straight forward swap out but make sure the pic is set correctly for opening and closing.
The difference brakes up the large expanse of under hood colour and compliments the hood leading edge strip too. These top quality parts made of polished stainless steel are a lot cheaper than you think! As Adam would say, “it’s all in the details”.
Adam has had a few of these Mustang Maniac laser cut key hooks made up, this time with five hook pins. If you are a good customer and make regular orders, you may find one of these in the next order as a little thank you, or if you are at the yard you ask Adam ‘nicely’ you may get one while the limited edition stock lasts of course. But, if you try to call him up to ask for one – you can pretty much bet your car keys you won’t get one!